Page 1 of 2

little help with the computer

PostPosted: Jun 8, 2004 @ 4:37pm
by SiGen

PostPosted: Jun 8, 2004 @ 4:52pm
by sp0om

PostPosted: Jun 8, 2004 @ 5:07pm
by Kzinti

PostPosted: Jun 8, 2004 @ 5:40pm
by refractor

PostPosted: Jun 8, 2004 @ 6:49pm
by SiGen

PostPosted: Jun 8, 2004 @ 7:44pm
by sponge
SMART is simply a diagnostic for HDs. If you suspect it may be an HD problem, enable that, and get any of the recovery tools that'll check the SMART codes.

PostPosted: Jun 8, 2004 @ 8:04pm
by glenthemole
If you suspect it could be the RAM, try running a memory diagnostic tool, or probably better, remove one stick, see if the problem goes, if not, then remove the other one and try again.

PostPosted: Jun 8, 2004 @ 8:35pm
by sponge
Or skip all of that guessing and run www.memtest86.com

PostPosted: Jun 8, 2004 @ 8:43pm
by glenthemole
I don't understand why some computers are more tolerant of bad RAM. I have one stick that has some problems with it according to memtest86, but it will work in one of my computers and not the other. What causes a pc to be more/less tolerant of dodgy RAM?

PostPosted: Jun 8, 2004 @ 10:16pm
by hockeydude

PostPosted: Jun 9, 2004 @ 4:59am
by SiGen
Thanks for all replies :) im going to take that memtest.

hockeydude: that exactly happens, takes 4-5 tries to make it reboot, thats why i guess is a hardware problem.

PostPosted: Jun 9, 2004 @ 5:14am
by SiGen

PostPosted: Jun 9, 2004 @ 5:29am
by sponge

PostPosted: Jun 9, 2004 @ 7:48am
by refractor

PostPosted: Jun 9, 2004 @ 11:35am
by sponge
refractor: Yes, when my entire computer died, SMART reported that one of the HDs was physically damaged. I'm not quite sure how a dead mobo can do that, but it seems to be right, as I can't do much with it.